How To Assemble My PetSafe® Outdoor Dog Fountain
Important Information
Before using the fountain for the first time, thoroughly wash all parts. For detailed instructions, visit our article How To Take Apart My PetSafe® Outdoor Dog Fountain Pump for Cleaning.
Disassemble and clean all the components of the pump. For detailed instructions, visit our article How To Disassemble & Clean My PetSafe® Outdoor Dog Fountain Pump.
After cleaning the pump, reassemble by replacing the impeller, stator, and faceplate.
Adjust the flow control dial to your desired setting. When the yellow tab is closest to the “+” sign, the pump is set at maximum flow. When the yellow tab is closest to the “-” sign, the pump is set at its lowest flow.
Replace the pump between the two posts on the bottom of the bowl. Press down to get the suction cups to adhere. Feed the pump cord through the slot on the side of the fountain and pull the slack. Feed the cord underneath the bowl and out the backside through the cord notch.
Place the foam filter around the pump.
Connect the Outflow Tube to the longest stem of the T-Tube. Then insert one of the short stems of the T-Tube into the opening on the bottom of the filter housing. Make sure the T-Tube is pressed all the way down so the little notch clips into the holder on the bottom of the housing.
Replace the filter housing by lining up the locking tabs with the openings on the top of the bowl. Gently push down until you hear the tabs lock in place.
Slide the two pre-filters into place with the raised lip facing out.
Rinse the charcoal filter under cold water to remove any loose charcoal dust. Insert the filter narrow side down with the black side facing out toward the bowl. Then replace the lid on the filter housing.
Place the fountain in your desired location. Fill the bowl with water to just over the triangle shaped shelf on either side.
Then fill both reservoirs with water and tighten on their caps. Replace the two reservoirs on the back of the fountain with the fill-line indicators in plain view. This will help you monitor the water level in your fountain and let you know when to refill the reservoirs.
The fountain is very heavy when full of water, never attempt to lift the fountain while it is full.
Make sure the electrical power cord, the adaptor and your hands are completely dry. Connect the cord to the plug and tighten the cord collar to secure. Then plug the adaptor into a standard electrical outlet.
IMPORTANT: If using an extension cord, ensure it is not damaged and has no exposed wires. Additionally, make sure it is a properly rated power cord for either indoor or outdoor use, depending on the placement of the fountain. If your pet is prone to chewing, be sure to protect the extension cord from your pet with a power cord protector, available in many forms at most hardware stores.