How To Empty the Waste and Add Litter to My PetSafe® ScoopFree® SmartSpin™ Self-Cleaning Litter Box
Before You Begin
You will want to have an additional waste bin liner and additional litter handy. Waste bin liners can be purchased on PetSafe.com.
Emptying the Waste Bin
A full waste bin will be indicated on the control panel with a red light above the trash can icon.
Remove the waste bin by sliding the drawer out from underneath the base of the litter box. The handle to the drawer is located PetSafe® logo on the front of the litter box. Pull the bin entirely out.
Remove the used liner from the waste bin. Cinch the liner closed using the drawstrings and tie shut.
Line the waste bin with a new liner. Fold the top of the new liner over the edge of the waste bin. The liner will not cover the front of the waste bin. Tuck the edge of the liner into the notches of the waste bin so that the deodorizeris not coveredand not sticking up so that it does not block the sensor that triggers the Waste Bin Full Light. Replace the waste bin in the base of the litter box.
Adding Litter:
Once the cleaning cycle is complete, press and hold the Cleaning Button for 3 seconds and release. An “A” will appear on the display indicating Add Litter Mode is enabled. If the Cat Entry Light comes on while pressing the Cleaning Button, you are pressing too hard. Wait until the light goes out before trying again.
Add litter, but do not exceed the MAX fill line located on the inside of the sphere around the edge of the rubber mat. Once the litter has been added, press and release the Cleaning Button one time and the“A” will disappear from the display. The litterbox is now ready for use.
Only add litter when in Add Litter Mode. Adding litter without being in this mode may cause the unit not to automatically clean.
Contact Customer Care
If you need further assistance, please contact our customer care team.