How to Clean Your Happy Ride® Dog Safety Seat

Unbuckle the seat belt and remove it from the safety seat.

Remove the reversible cushion.

Remove the seat belt tether.

Lift up on the fabric liner to release the hook and loop fasteners. Remove the liner.

Unzip the fabric cover and remove from the seat frame.

Wipe the frame with unscented soap and warm water.

Wash the fabric pieces with cold water and line dry.

Turn the frame upside down.

Open the zipper at the back corner of the fabric cover and slide it onto the bottom of the frame. The zipper will line up with corner H.

Continue pulling the cover over the frame until the bottom panel of the cover aligns with the bottom of the frame.

Turn the frame right-side up. Pull the cover over the edges and close the zipper. The seatbelt slits will line up with the holes in the safety seat.

Insert the fabric liner into the seat. The slit in the liner will align with the opening in the back of the seat.

Insert the fabric liner into the seat. The slit in the liner will align with the opening in the back of the seat.

Insert the large loop of the seat belt tether, opposite the clip, through the opening in the liner and the frame.

Insert the large loop of the seat belt tether, opposite the clip, through the opening in the liner and the frame.

Pass your vehicle’s seat belt through the opening, the seat belt tether, and the opening on the other side of the frame. Buckle to secure.

Important: Refer to your vehicle’s manual for information on locking the seat belt. This is typically found with information regarding child restraint installation.

Once your pet has adjusted to the seat, attach the tether to his harness. Adjust the tether so that he cannot jump out of the seat.

Important: Do not attach the seat belt tether to your pet’s collar.