How to Clean Your Drinkwell® Pagoda Pet Fountain
How to Clean Drinkwell® Pagoda Pet Fountain
The fountain should be cleaned at least once a month to avoid mineral buildup and to ensure clean drinking water for your pet.
Multi-pet households may need to clean every two weeks.
It is recommended to clean the pump and change the filter when cleaning the fountain.
Disassemble the Fountain
How to Disassemble Drinkwell® Pagoda Pet Fountain
Remove the tower from the bowl.
Remove the filter housing from the pump.
Peel off the rubber cap from the stem.
Pull the pump cord out through the stem and remove the pump. Set the pump aside.
Remove the foam filter.
Clean the fountain and all removed parts except for the pump with soap and warm water.
The bowl and tower are dishwasher safe on top rack only.
Note: If there is leftover residue, soak the fountain in white vinegar and warm water for 30 minutes. Wash again with soap and warm water before use.
Rinse the Filters
Rinse the carbon filter under warm water for 30 seconds before use. Loose black particles will rinse out from the filter and can be seen in the bowl if the filter is not rinsed thoroughly. The carbon is made from coconut shells and is safe for your pet.
Rinse the foam filter under warm water for 30 seconds before use. This filter will remove hair and other small particles. Replace if damage is noticed.
Disassemble the Pump
Note: Place the pump parts in a safe place to avoid dropping them down the drain.
Use a tool with a small, flat edge to remove the faceplate on the end opposite to the cord.
Pull up on the small lip to remove the teardrop shaped stator.
Remove the impeller by pulling up from underneath the white disk.
Note: The impeller is held in place by a magnet. This may give some resistance when trying to remove.
Clean all parts of the pump using soap and warm water with a small brush. Completely rinse the pump, then reassemble.
If hard water build up occurs, soak pump in equal parts vinegar and warm water for 15 minutes, then scrub.
Reassemble the Pump
Place the impeller, stator and faceplate back onto the base to reassemble the pump.
Reassemble the Fountain
How to Assemble Drinkwell® Pagoda Pet Fountain
Place the foam filter on top of the square in the bowl of the fountain.
Set the pump in the foam filter and run the cord down the stem and out the bottom.
Fold the rubber cap over the stem, allowing the cord to sit in the notch at the bottom of the cap.
Align the carbon filter with the filter housing and insert.
Insert the bottom of the filter housing into the circular hole on the pump.
Place the tower over the filter housing. Align the top of the housing with the opening in the tower.
Pour water into the fountain bowl, leaving an inch of room from the edge.
Connect the pump cord to the power adapter and plug it into a standard electrical outlet.
Contact Customer Care
If you need further assistance, please contact our customer care team.