How to Change the Simply Clean® Bowl Motor

Remove the conveyor cover and waste bin.

Loosen the thumb screws that secure the conveyor to the base.

Lift the conveyor up and remove the bowl.

Lower the conveyor to its original position and carefully flip the Simply Clean® Litter Box over.

Use a Phillips screwdriver to unscrew the two screws at the top of the base. Then, slide the motor out to remove it from the base.

Press and pull the middle of the clip to release the locking mechanism to disconnect the wires.

Connect the bowl motor wire to the base unit wire.

Slide the motor back into position and align the screw holes. Insert the two screws and tighten with a Phillips screwdriver.

Carefully turn the Simply Clean® Litter Box back in the upright position.

Lift up the conveyor and place the bowl back into the unit.

Tighten the thumb screws to secure the conveyor to the bowl.

Place the conveyor cover and waste system back onto the litter system.

Line up a piece of tape on the bowl with another piece of tape on the base unit.

Check the location of the tape on the bowl after a few minutes. The pieces of tape should be a few inches apart.

Check that the green light on the back is lit to confirm power.

Make sure the conveyor cover is securely in place and the waste bin is properly installed. If they are not, the system will not have power.

Inspect the bowl motor connection on the bottom of the unit to confirm that it is completely attached.

If you need further assistance, please contact our customer care team.