How to Assemble the PetSafe® ScoopFree® SmartSpin™ Self-Cleaning Litter Box
Before You Begin:
Confirm all the parts are accounted for and that a 2.4GHz Wi-Fi network is available for connection.
Do not throw away any packaging until setup is complete. Assembly can be done on top of plastic packaging and with the use of the gloves provided to prevent scratching.
Place the base upside down and insert the 4 wooden legs into the base. Ensure the legs are fully seated into the holes to prevent wobbling.
Turn the base right side up. Insert the bracket into the base. You will hear a click when it is locked into place.
Remove the cover from the deodorizer and place the deodorizer in the holder of the waste bin.
Line the waste bin with the liner. Fold the top of the liner over the edge of the waste bin. The liner will not cover the front of the waste bin. Tuck the edge of the liner into the notches of the waste bin so that the deodorizeris not covered.
Slide the waste bin into the front of the ScoopFree® SmartSpin™ base.
Place the front half of the sphere so that the entry hole is face down.
Insert the Litter Saver (A) so that it aligns with sticker (A) inside the sphere. The rounded edge of the Litter Saver will fit in the notch around the entry hole.
Insert the rubber mat (B) so that it aligns with the sticker (B) inside the sphere.
Place the red alignment tool into the hole in the edge of the Litter Saver.
Place the back half of the sphere on top of the front half. Align the top so the alignment tool goes through the small hole.
Line the screw holes up and place the screws in the 8 holes, starting in the back of the sphere. Work in a star pattern. Only screw in the screws loosely.
Once all the screws are loosely in place, tighten each screw until they are hand-tight.
Important: Save the screwdriver and red alignment tool with the litter box. It will be needed for future assembly/disassembly.
Install the Litter Sifter into place inside the sphere. Align the end marked (C) with the sticker C inside the sphere.
Open the bracket latch on the base.
Place the sphere in the base. Close the latch around the knob on the back of the sphere.
Assemble the cover. Snap the tabs into place by aligning the D stickers together and the E stickers together. The cover will resemble an arch when assembled.
Place the cover over the top of the sphere. Make sure the arrows are pointing toward the front of the litter box. Push the bottoms of the cover in toward the base of the sphere until all 4 magnets are firmly in place.
Plug the power adaptor into the port next to the bracket on the back of the ScoopFree® SmartSpin™. Then plug the other end of the adaptor into a wall outlet.
Lightly press and hold the Cleaning Button for 3 seconds and release. If the Cat Entry Light comes on while pressing the Cleaning Button, you are pressing too hard. Wait until the light goes out before trying again. There will be an “A” on the display, indicating Add Litter Mode. Fill the litter box using a high-quality litter to the MAX fill line inside the sphere. Once litter has been added, press and release the Cleaning Button to exit Add Litter Mode.
Download the PetSafe® SmartSpin™ Litter Box app. Follow the in-app prompts to connect your SmartSpin™. For additional help connecting to your litter box, visit How To Connect My PetSafe® ScoopFree® SmartSpin™ Self-Cleaning Litter Box to the App.
Contact Customer Care
If you need further assistance, please contact our customer care team.